Bio-rad Model 583 Gel Drying Supports Manual do Utilizador

INSTRUCTION MANUALCatalog Numbers165-1781165-1782165-1789165-1790HYDROTECH™ VACUUM PUMPHydroTech Vacuum Pump

3.0 MAINTENANCE AND TROUBLESHOOTING3.1 MAINTENANCEThe HydroTech pump’s reservoir water should be changed at least once a month or if frequent use of t

3.2 TROUBLESHOOTING GUIDERefer to Table 6, Troubleshooting Guide, for HydroTech Vacuum Pump troubleshooting. For further assis-tance, call 1-800-4BIO

APPENDIX A. APPROXIMATE GEL DRYING TIMESThe following table provides approximate drying times for various gel concentrations, given the gel dryer’stem

APPENDIX B. SPECIFICATIONSVacuumStarting > 29” Hg (23.4 Torr)After 10 hours > 28” Hg at 22° C (48.8 Torr)At 35° C RT > 26” Hg at start (99.6

APPENDIX C. WARRANTY AND ORDERING INFORMATIONThe HydroTech Vacuum Pump is warranted for 1 year against defects in materials and workmanship. If anyde

WARRANTY INFORMATIONModel: ______________________________________________________________________Serial Number:_______________________________________

Life ScienceGroupWeb site www.bio-rad.com Bio-Rad Laboratories Main Office 2000 Alfred Nobel Drive, Hercules, CA 94547, Ph. (510) 741-1000, Fx. (510)

Table of ContentsTABLE OF CONTENTSSafety ...

SafetySAFETYCaution/WarningNo user-serviceable parts are inside. Refer servicing to Bio-Rad service personnel. This instrument is intended for labor

1.0 INTRODUCTIONBio-Rad’s HydroTech Vacuum Pump is designed for use with the Model 583 Gel Dryer or any other conven-tional slab gel dryer. It uses w

1.2 PHYSICAL DESCRIPTIONTable 1.Front View Physical FeaturesFeature Description1. Vacuum Inlet Quick disconnect valve for connecting to the gel dryer’

Table 2.Rear View Physical FeaturesFeature Description1. Reservoir Storage tank for recirculating water.2. Reservoir Cap Screw-on cap for water reserv

2.0 SET UP AND BASIC OPERATIONThe HydroTech Vacuum Pump is shipped fully assembled. To use the pump, simply fill the reservoir withwater and attach t

Table 3 (continued)HydroTech Set UpStep Procedure Description2. Connect the AC power cord. Plug the AC power cord into the HydroTech power inputmodule

2.3 BASIC OPERATIONWarningTurn the vacuum line’s two-way valve to the closed position when the dryer is not in use; the vacuum pump then can continue