Bio-rad BioLogic Mixers Manual do Utilizador descarregar pdf (Página 2)

Be sure to follow these directions carefully. If the mixer is assembled incorrectly, or if an o-ring is

not correctly placed in the o-ring groove, the mixer will leak.

1. Use the hex key provided (or any 3/16” hex key) to remove the four screws from the top of the

mixer.

2. Remove the mixer top and turn it upside down to remove the o-ring. If the o-ring does not easily

dislodge, use your fingers to remove it.

3. Refer to Figure 2 for re-assembling the mixer. Make sure that the magnetic stir bar lies flat and that

the o-ring groove in either the mixer body or the mixer extender barrel faces up.

4. Place an o-ring in each o-ring groove. If you are using only the mixer body (750 µl), then only one

o-ring is required. If either the standard mixer barrel or the barrel extender is used, then two

o-rings are required.

Figure 2. Mixer Assembly

Technical Assistance

For additional help, contact your local Bio-Rad representative. In the United States, call Technical

Service at 1-800-4BIORAD.

Ordering Information

760-2010 Maximizer Mixer Kit

760-2005 5 ml barrel extender installed

760-2012 12 ml barrel extender

MIXER

TOP

SCREWS

MIXER

BODY

12 ml MIXER

BARREL

OUTLET PORT

5 ml MIXER

BARREL EXTENDER

INLET PORT

MAGNETIC

STIR BAR

O-RING

O-RING GROOVE

ASSEMBLY OF THE MAXIMIZER MIXER

4106527 Rev A

Bio-Rad Laboratories, 2000 Alfred Nobel Drive, Hercules CA 94547

1 2

Sem comentários

Bio-rad BioLogic Mixers Manual do Utilizador Página 2