Bio-rad ChromLab™ Software Manual do Utilizador descarregar pdf (Página 41)

Connecting the Drain Tube to the Buffer Tray

Installation Guide | 3 9

Connecting the Drain Tube to the Buffer Tray

The top of the NGC system is molded to contain the buffer tray and route its drain

tube to the right or left side of the instrument. The drain tube connects to the buffer

tray through a connector on the back of the instrument top.

Note: The drain tube connector is barbed to keep the tube tightly in position.

After it is secur

ely attached to the connector, the tube will be very difficult to

remove. Plan your setup carefully before attaching the drain tube to the

connector.

To connect the drain tube to the buffer tray

1. Locate the instrument top and buffer tray.

2. Place the top upside down on the lab counter with the back side of the tray

facing towar

d you.

3. Determine the side of the instrument on which to place your waste container

and then locate the corr

esponding right or left drain tube hole in the top.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 177 178

Sem comentários

Bio-rad ChromLab™ Software Manual do Utilizador Página 41